Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
The device won’t use as much, but higher current is okay because it will “fry” it. Since the device won’t have enough power, lower current isn’t likely to cause damage, but it can cause trouble if the power supply isn’t enough.
6-volt cells are used to supply electricity to torch lights, flashlights, or any other illumination that requires higher energy capacity. These batteries have a large capacity for energy storage because they are rechargeable batteries with multiple cells inside.
If you are comfortable with electronic circuits, you can convert the 6V to 5V. The output of the adapter can be connected to a 5V linear regulator, which will have a 200mA dropout.
You can run a 6V motor at 9V, but it won’t last as long. If you can be certain that the original PSU was not unregulated, you can use a 6V or 9V adaptor.
Is it possible to use a 7.5 Vadapter for 9v? There are 7.5v devices with tolerances wide enough that 9v won’t make a difference.
Even if you found an 8V 2.6A power adapter, it might not be safe if you don’t know if the old one was regulated. If it is not regulated, it is possible that the gadget depends on the particular behavior of the adapter.
I’m pretty sure it charges a 6V battery directly or almost directly. Through something. The battery may die early because of higher voltages. 2.6 Amps is relatively high current, so you should be able to find an adjusted supply. It’s expensive.
Maybe to 9V DC 2A. It is not safe to assume that either will work. Even if you found an 8V 2.6A power adapter, it might not be safe if you don’t know if the old one was regulated.
If the current on the device is the same as the current on the adapter, then the device may work. The effect of low voltage depends on the complexity of the device.