Physical Address

304 North Cardinal St.
Dorchester Center, MA 02124

How Do I Setup My PROLiNK Router?

MODEM IP and Login are used. You can type at Web Browser. Click setup, click basic, click security, and then click apply changes.

How Do I Configure A WLAN Router?

The steps for setting up a routers

Decide where to put the routers. Step 2 is connecting to the internet. /li>li>Step 3 The fourth step is connecting the gateway to the routers. Step 5 is using an app or web dashboard. Step 6 is to create a usernames and passwords. /li>li>Step 7 is to update the router’s software. Step 8 is to create a wi-fi password.

How To Use WPS Button On Router?

How to connect your device to the internet.

Go to the settings app and tap the WPS connection button. On your phone, you can choose whether you want to use the internet or not. /li>li>Choose if you want a Push Button or Pin Entry.

What Is WIFI Router Configuration?

You need to set these general settings for your routers. The setting of a local area network. The setting of the DHCP protocol. You need to set up additional wireless settings after that to connect a computer to it.

How Do I Access My PROLiNK Router?

There is a guide for the PROLiNK Router.

Open your browser. 192.168 is the type of browser used. The address bar of your web browser should be 123.254, the most common one for PROLiNK.

How Do I Reset My PROLiNK Wireless Router?

Hold the reset button for 30 seconds when your PROLiNK is powered on. The reset button should be held for another 30 seconds after the power is turned off.

Should I Press The WPS Button On My Router?

Press the button to connect. It can take a few minutes to connect. There is a light that flashes when the connection is established.

What Kind Of Router Does Prolink Pwh2004 Have?

The PROLiNK PWH2004 is a draft 802.11n/b/g compliant Wireless broadband Router.

How To Set Up Prolink Wireless Router With PPPoE?

This manual setting is deleted by the account. The same password, adsl035420xxx, is used to access the internet. The person doesn’t need to create a dial up or dail when using the mode.

How To Check If Your Prolink Wireless Router Is Working?

NT gives you a password and a usernames for your computer. This mode is used to connect a computer. After you connect your modem to the phone line, the ADSL led will blink and glow continuously.

What’s The Best Way To Set Up A Wireless Router?

Setting up a routers is much easier with the bundled software. The name of your wireless network and the type of security you want to use can be specified using the software. The most secure network should be chosen by you. You can choose a password.