The table is routed.
The best path to use to send packets is the primary function of a routers. The best path is determined by the router’s search for a network address that matches the destination address of the packet.
Which Command Will Display Which Routes The RIPv2 Router Is Advertising?
You can use the command to see live advertisements. In this example, you can see how advertisements are being sent to a broadcast destination. It is getting updates from B. The serial interface is 1.2.
What Does RIP Use To Reduce Convergence Time In A Larger Network?
35 is the number. Reducing convergence time in a larger network is something RIP does. If there are more than 10 routes, the update timer is reduced to 15 seconds. Network changes can be announced if they happen in between periodic updates.
How Do I Check My Router For Rips?
The showip rip route command can be used in any mode to display route information.
How Do I Enable RIPv2?
If you want to enable RIPv2 by default, you have to be a member of theCisco network. The ver 2 command is used in the configuration mode. The RIP summarizes the updates. No auto-summary can be used to disabling this.
Why Eigrp Is Faster Convergence Than OSPF?
The network convergence time is faster because the network learns the information faster. Data packets in the EIGRP network reach the destination quicker than those in the OSPF network. The packet loss in the OSPF network is higher than in the EIGRP network.
What Is Summary Address Can Router2 Advertise To Router1 To Reach The Three Networks?
What can Router2 do to reach the three networks on Routers 3, 4, and 5 without advertising the public address space? A new date. There are problems with the network in the diagram. The addressing scheme may be the problem.
Where Does Router1 Have A Route To 172.16.0.0?
The administrator discovered that Router1 does not have a route. Reach network 172.16.0.0 if Router2 is configured correctly. Choose two. What is the exhibit about? Choose two. Cumberland and Montgomery have Layer 2 connections. They are connected to Montgomery. Refer to it.
How To Show Ip Route Command In R2?
Packets that are routed to the R2 interface need two table searches. Refer to it. The results of the show can be seen in a graphic. Which route will be used for the packet with the destination address? Refer to it. There are two destined for which.
Which Is Route Will R1 Install In Its Routing Table?
R1 knows the routes Path A and Path B. R1 learned Path A and Path B from a static route. Which route will R1 use?